iPhone | How to Unlock a 1.1.1 or 1.1.2 Upgraded iPhone Using Windows(3)

Author: web Add date: 04/16/2008 Publishing date: 04/17/2008 Hits: 0

Total 3 pages, Current page:3, Jump to page:

Step Two
Reboot your phone by holding down the Sleep/Wake button for three seconds. Move the power slider to right to power down. Then press the Sleep/Wake button again to power back on.

http://hongblog.net

Launch iTunes.

Name your iPhone if it asks then click the Done button.

Step Three
If you get a dialog window asking you to update to then click the Install button.

Otherwise click the Update button to update to 1.1.2

Once complete a dialog box will appear letting you know you have updated successfully.

When it finishes updating, the iPhone will have been restarted. The new emergency slider and connect to iTunes image will be on the iPhone.

Step Four
Close iTunes then extract the 1.1.2-jailbreak.jar we downloaded earlier. A folder will be extracted called 1.1.2-jailbreak.

Double click windows.bat from within this folder to start the jailbreak.

Step Five
A popup will appear asking you to enter the desired password and whether or not to enable SSH. Make sure you check to enable SSH and then press Jailbreak!

Whens it done a popup will appear letting you know the jailbreak has been successful! During this process the phone may be rebooted a few times.

Step Six
From your springboard press to run the Installer application.

Press to select the Install tab at the bottom.

Press to open the System category.

From the System Category press to select BSD Subsystem.

Then press the Install button at the top right of the screen. When prompted select Install again to begin the installation.

Once the install has finished you will be placed back at the Category list.

Step Seven
Extract ipetools.zip that we downloaded earlier. You will extract a folder called ipetools. Inside this folder is "ipe-lockdownd-tools.tgz". We need to copy this to the iPhone.

Go back to WinSCP. Log back into your iPhone using the same procedure as before.

On the left navigate to the folder that contains "ipe-lockdownd-tools.tgz" and on the right navigate to your root directory. Copy "ipe-lockdownd-tools.tgz" to your root directory.

Step Eight
Select Open Terminal from the Commands menu.

You may be asked to Confirm. Click Ok.

Step Nine
Enter the following commands then press the Execute button after each line:

cd /
cp /usr/libexec/lockdownd /usr/libexec/lockdownd.bak
tar -xvzf ipe-lockdownd-tools.tgz
cd ipetools
./ipatcher -a

Step Ten
Reboot your phone by holding down the Sleep/Wake button for three seconds. Move the power slider to right to power down. Then press the Sleep/Wake button again to power back on.

Step Eleven
Go back to WinSCP. Log back into your iPhone using the same procedure as before.

Step Twelve
Select Open Terminal from the Commands menu.

You may be asked to Confirm. Click Ok.

Step Thirteen
Enter the following commands then press the Execute button after each line:

killall -9 lockdownd
cd /ipetools
./bricktool

Step Fourteen
Reboot your phone by holding down the Sleep/Wake button for three seconds. Move the power slider to right to power down. Then press the Sleep/Wake button again to power back on.

You can now put in any SIM. You have an unlocked iPhone!!!

THANKS:

Other pages: : <<Prev * 1 * 2 * 3

Prev:iphone problem pls help

Next:Guide: How to downgrade from 1.1.2 to 1.0.2.

Comment:

Category: Home -> iphone